![]() SNAPPY SEALER applied, after the deck is dry, will preserve your deck the entire season. ![]() ![]() These areas will blend together leaving no seams. If this be the case use alternative No.2, that is apply liquid No. If after drying an area has been missed, or does not look optimal, just repeat the process for just that area. It is best at this time to rinse the entire boat. Wait 5 minutes, then wipe a clean cloth over. Follow direction of wood grain during application to maximize penetration of oil into wood. Apply Snappy Teak-Nu® Premium Marine Teak Oil to dry teak surfaces using a clean cloth, sponge or brush. Again wait a few minutes so the liquid can work deep down.Ħ. An easy and affordable way to recondition teak, this two-step system removes mildew stains, fuel, fish blood and many other hard to remove stains without. Directions: If wood is dirty and/or weathered, first treat it with Snappy Teak-Nu® Formulas 1 and 2. Almost immediately your deck will begin to lighten in color. Use exactly the same technique as used when applying liquid No.1. This mixture is also better for the environment.ĥ. This creates a neutral mixture which cannot effect aluminium when it is rinsed off at a later time. directly on top of liquid No1 without rinsing. If, however, you do have aluminium use alternative number 2. Before rinsing however, wait a few minutes so that SNAPPY can work deep down in the wood. If you do not have aluminium in the area you can rinse away liquid No.1, with water. Do not be afraid that your deck turns almost black in color. If SNAPPY begins to dry into the deck (sunny day) spray lightly with water. Do not mix the brushes as the two liquids(No.1&2) neutralize each other. Brush across the grain using a force equal to that force you use when you wash your hands. Taping the aluminium protects it, and even waxing helps.ģ. The same is true of some simple varnishes. ![]() Softened teak is easy to damage with vigorous brushing, so be careful! If you get SNAPPY No.1 on aluminium spray immediately with water, as miscoloring can result. Water however, makes the soft teak even softer. The deck must be thoroughly wet before applying Snappy Teak – Nu. On decks that are not warn down soft white “Scotch Brite” pads may be used instead of the special brushes supplied.Ģ. If the deck is in bad shape concentrated SNAPPY may be used, otherwise dilute 1:1 with water. You will also need a hose with spray nozzle and buckets for diluting SNAPPY. Step 1 of our easy to use two-part teak cleaner and restorer Must use with Step 2 as the chemical reaction between the two products is what makes teak. It is important to use rubber protective clothing (rain wear) as well as eye goggles. Make sure that you have everything you need before you start. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |